Questions & Answers

After step 13 of programing, all three lights are flashing not just yellow and red.

0 votes
While programing the Evo All, stand alone starter, with mazda t-harness, I'm not getting the yellow and red flashing lights after step 13. Instead all three lights flash at the same time. If I hook it up to the flash link to use the Dcryptor, it's says there is incomplete key information. I don't know what to do from here. Any suggestions. I did try a factory refresh but am getting the same thing. Everything seams to go right up to step 13.
asked Dec 5, 2016 in Mazda by David Dankanyin (130 points)
edited Dec 5, 2016 by David Dankanyin

2 Answers

+1 vote
EXACT SAME PROBLEM SLOVED

WAS WORKING ON A 2018 CX-9

STEP 13 KEPT FAILLING

THE FLASH SOFTWARE KEPT SUGGESTING FIRMWARE VERSION AS 71.XX

BUT THE INSTRUCTIONS SAY MINIMUM FIRWARE HAS TO BE 85.11

I MANUALLY SELECTED THE 85.11 VERSION AND THEN TRIED THE PROGRAMMING PROCESS AGAIN.

STEP 13 WAS A SUCCESS AND THE DCRYPTOR PROCESS COMPLETED
answered May 19 by Talha Saleem (170 points)
0 votes
Service number to the module?

Guide number you are following?
answered Dec 5, 2016 by derek g (342,860 points)
Guide number 35191 Don't have the module in front of me for the service number.
commented Dec 5, 2016 by David Dankanyin (130 points)
Alright, once you have the service number let me know I will take a look inside the module to see why this is happening.
commented Dec 5, 2016 by derek g (342,860 points)
Sorry for the delay..... service number is 003606 005321
commented Dec 5, 2016 by David Dankanyin (130 points)
If you are using a t-harness what did you hook up the lt.blue/black wire to in the car?
commented Dec 5, 2016 by derek g (342,860 points)
Blue/black wire is connected to the black/white data key wire on the factory harness. As per the instructions.
commented Dec 5, 2016 by David Dankanyin (130 points)
How did you make the connection?
commented Dec 5, 2016 by derek g (342,860 points)
With supplied crimp connector. Do you think this is the cause?
commented Dec 5, 2016 by David Dankanyin (130 points)
could be...I would suggest removing it and making a proper splice connection...This goes for any other wires you used the crimp connectors on.
commented Dec 5, 2016 by derek g (342,860 points)
Ok went through all the connections and reattached them the proper way. Now when I get to step 13 just the red light flashes. When I hook up the evo to the flash link I still get the same incomplete key information. Any other suggestions?
commented Dec 8, 2016 by David Dankanyin (130 points)
I am having the same issue on a 2017 Mazda 3 Push to Start Automatic. Installed with T Harness Thar Maz1. Spliced into Key data and Door locks on second connector under steering column. Tried changing flash version on Evo All. Newest or minimum specified version doesnt work either.
commented Nov 18, 2020 by michael kopytek (150 points)
same issue on mazda cx5 2018 push to start automatic!!!
commented Dec 31, 2020 by Ahmed Alhammad (140 points)
I have the same problem, reset evo all madule and nothing change
commented Apr 13, 2021 by Nazaret Gutierrez (100 points)

Related questions

...