Questions & Answers

evo one programming can't get out of step 1-4 yellow led don't flash 2014 chevy silverado

0 votes
evo one programming can't get out of step 1-4 yellow led don't flash 2014 chevy silverado i check all my wires and i think they are in the spot. how do i know if vehicle is in the right firmware why programming is complicated for all in one universal module.
asked Nov 8, 2019 in Chevrolet by Kid Ratits (470 points)
edited Nov 10, 2019 by Kid Ratits

1 Answer

0 votes
what is the 12 digit service number of the module?

Which t-harness are you using?
answered Nov 8, 2019 by Robert T (300,340 points)
i used regular installation SN# 002B04034481
commented Nov 8, 2019 by Kid Ratits (470 points)
If you are not using a t-harness, check your DATA wire and make sure that it's on the middle pin of the immobilizer connector. There are 2 green wires in that connector that can easily be mixed up.

 

Also, use the latest 70.38 firmware.
commented Nov 8, 2019 by Robert T (300,340 points)
i was at 70.38 but don't work so i flash it 70.28 but still don't work. i have to check the data wire when i get home after work. thanks
commented Nov 8, 2019 by Kid Ratits (470 points)
it didn't work i checked my wiring and everything are ok. they are in the right wire where should connect i flashed it to 70.38 led still in solid yellow can't moved to next step of programming and i forgot to mention that i had factory command start but i wan't long range transmmiting command start. is there a conflict because of my factory command start?
commented Nov 9, 2019 by Kid Ratits (470 points)
edited Nov 9, 2019 by Kid Ratits

Related questions

...