purple connect directly to alarm, detects doors correctly but 22 seconds after arm alarm goes off and reports door

1 Answer

The Door pin connection is used to shut down the auto lights (RAP) after remote start and should not be connected to the remote starter door trigger input. This is an output from the EVO and has nothing to do with door status.

The door status output you are looking for on the EVO-ALL is the Green wire (not the pink/black). Connect that to the viper door status input.

Basically, follow the installation guide connections that are dotted line. Do not use Datalink if you cannot change the EVO-ALL datalink protocol to D2D so that it is compatible with the VIper system. (cut the blue and white wires in the datalink connector when doing the regular wiring)

answered Oct 14, 2014 by Robert T (300,340 points)

So there is no door pin connection required for the evo to detect the door ? it does not sense the door via can bus

asked Oct 14, 2014 in Dodge by Gavin CHING (420 points)

Questions & Answers

purple connect directly to alarm, detects doors correctly but 22 seconds after arm alarm goes off and reports door

Please log in or register to answer this question.

1 Answer

Please log in or register to add a comment.

Questions & Answers

purple connect directly to alarm, detects doors correctly but 22 seconds after arm alarm goes off and reports door

Please log in or register to answer this question.

1 Answer

Please log in or register to add a comment.

Related questions