2019 Qashqai vehicle has no crank no start when the module is plugged in.

Question

2019 Nissan Qashqai, automatic, key-start. Installed Evo-all with T-harness. Stand alone install.

Evo-all programmed fine. Got the correct lights when programming, dcryptor went through fine. Installed the module back in the vehicle after dcryptor, the vehicle will not crank / start.  Unplugged module, left the t-harness connected, vehicle starts fine (with a bunch of codes). Cleared the codes, re-installed Evo all module, no crank / no start.

Also, the evo-all module does not light up / respond to the vehicle FOB (I.e. no light flashes when pressing lock or unlock)

Things I have done so far: checked t-harness (pin location, made sure plugs are seated properly). Removed t-harness, vehicle starts fine, re-installed t-harness, vehicle starts fine, re-installed Evo all module, same issue, no crank / no start.

Downgraded firmware to minimum, no changes.

SN 001A07 284515

Current firmware loaded - 72.52

I have not tried to replace evo-all with a different one.

Could the evo-all module be bad?

Thanks.

Answer 1

Hello,

That is not normal, the vehicle should start with the harness/evo connected.

I would try another evo-all or t-harness in this case.

Best regards.