2013 Audi A7 Wont Start, key not recognised

Question

I'm currently using an evo one  SN: 002B04 079929

I'm trying to program this for an audi a7 2013. I've upgraded the correct firmware as per the manual however i'm getting an issue when attempting to remote start. It shows on the dash key not detected every time.

I've done this 3 times now and the 3rd time the Decryptor limit has been reached.

Can you advise and then reset please?

The programming went fine, all the lights appeared as shown.

If i leave the key in the car and remote start it, its fine. but if i do it outside the vehicle it displays key not recognised.

Thanks

Answer 1

Hello,

I have submitted your module for reset, it will be ready for use within 24 hours. 

 

Once you re program the module and re dcrypt it, if it still does not work please call into technical support when you are at the vehicle with the module so an agent can go through it with you to determine why it isn't starting. 

 

1-877-336-7797

mon - fri

8 - 6 est.

 

Best regards.

 

Answer 2

Did you sort this out?  I just installed and have the same issue.  If I wire it to run with my spare key in the vehicle it works but the install without sacrificing a key gives me key fob not found message in display.  2012 A7 here also.

Answer 3

Did you sort this out?  I just installed and have the same issue.  If I wire it to run with my spare key in the vehicle it works but the install without sacrificing a key gives me key fob not found message in display.  2012 A7 here also.

Answer 4

Did you sort this out?  I just installed and have the same issue.  If I wire it to run with my spare key in the vehicle it works but the install without sacrificing a key gives me key fob not found message in display.  2012 A7 here also.

Answer 5

Did you sort this out?  I just installed and have the same issue.  If I wire it to run with my spare key in the vehicle it works but the install without sacrificing a key gives me key fob not found message in display.  2012 A7 here also.

Answer 6

Did you sort this out?  I just installed and have the same issue.  If I wire it to run with my spare key in the vehicle it works but the install without sacrificing a key gives me key fob not found message in display.  2012 A7 here also.