2020 Buick encore installation clarification

Question

I have Purchased a Evo-GMT6 with THAR-GM6 harness for a 2020 Buick Encore push start and im looking for clarification.

1.On page 4(wiring diagram) of guide #77331, shows to make a connection between the light blue wire and light blue/black wire. Do these need to be spliced together? What is the reason for this?

2. Also, wondering what start/stop external control means?

3. Are the good hood pins/ valet switch required for the function of the module?

Thanks,

Brad

Answer 1

Hello,

1.On page 4(wiring diagram) of guide #77331, shows to make a connection between the light blue wire and light blue/black wire. Do these need to be spliced together? What is the reason for this?

- If your module was made before 2019 yes, if it was made after 2019 no. Fabrication date is written on the back.

2. Also, wondering what start/stop external control means?

- This is for a 3rd party device to control the evo, in your case you will not need it.

3. Are the good hood pins/ valet switch required for the function of the module?

- If the vehicle is equipped with an oem hood pin, refer to your vehicle specific guide to see if the evo covers it through data. If no then it is strongly recommended to install a hood pin for saftey reasons. It will still function without that connection.

 

Best regards.