NO FLASHING BLUE LIGHT AT STAGE 5

Question

2014 VOLKSWAGON JETTA TDI AUTOMATIC TRANS
AFTER REPROGRAMMING EVO ONE 3 TIMES STILL CANT GET THE EVO ONE BLUE LIGHT TO FLASH AFTER TURNING ON IGNITION, BLUE STAYS LIT THEN WHEN IGNITION IS ON LIGHT GOES OUT UNTILL YOU TURN IGNITION BACK OFF THEN BLUE LIGHT COMES BACK ON?

FORTIN EVO-ONE W/
VWT1 T HARNESS
DATE 12/2021
s/n 002b04 248922
firmware remote start = 1.[26]  hardware 7.0
BYPASS = 75.[41]
hardware 4.0
loaded suggested options on both with diesel option checked

Answer 1

Hello,

 

Is this installation being done with or without the vwt1 harness?

 

Best regards.

Comments

with, sorry forgot to mention

---

with and also its a 2014
my appologies for caps i just noticed thet were on at my first mesg

---

Your t-harness might not be plugged into the correct connector. The connecter you want is in the back of the steering column module. Check the guide, bottom left of page 3. https://fortin.ca/download/65321/evo-one_ig_thr_bi_vol1-jetta_2011-2014_pts_tb_c_65321.pdf

---

ok, you were exactly right i had it plugged into the top plug, so after i switched those around and hooked up the 2 orange CAN wires that my guide didnt show me to use , I am now getting the car go like its going to remote start but doesnt? the Jetta's lights flash the dash lights come on, the evo's lights flash then stay on solid red & orange and i did see "brake" flash once on the LCD screen on the dash, so now im wondering if it has something to do with the brake peddle needing pressed?

THANK YOU, for your help

---

ok now after checking and triple checking my conections after the T harness plug switch, i have everything correct except for the trunk because i did not know i needed a diod so if this is causing my final delema then i will order but i didnt thin i needed it right now to test and start the vehical?

i have everything working if i keep the driver door open and push on the brake pedal starts with 3 presses of the lock button but as soon as i close the door i get nothing not even ignition on

so please could you let me know what i need to switch or wire up to get this thing done?because this is going on 3 days now back an forth.  my bay and lift plugged up so the wife is starting to get a little peeved at me now
if i cant get it on this go around wife said to put it back together without it and ill have to be her remote start again ;(

---

oh  and i am using a spare key wrapped with the 2 wires, it looks like the guide you sent me was for the NO key option, so im going to cut the 2 wires that guide was showing me to connect to the ODD2 connector and see if that helps while i wait for your replay here

---

This would be the key required installation: https://fortin.ca/download/65311/evo-one_ig_thr_bi_vol1-jetta_2011-2014_pts_a_65311.pdf

 

Be sure the options listed on page 1 & 2 are set accordingly.

 

Yes the brake connection is required on this vehicle.

 

Tips for key wrap procedure can be found on page 6.