2016 Impreza DCRYPTOR Programming Procedure not working

Question

2016 Subaru Impreza, Thar-One-Sub1 Standard key. Auto Transmission

All programming and firmweare updates appear to be correct.  When doing the DCRYPTOR Programming Procedure at step 5 the lights do not blink.  Red and Blue remain solid.

Answer 1

What is the S/n number on the back of the unit?

Comments

002B04 013034

---

The firmware in your module is correct for the vehicle.

Please try the following test to see if you are able to program just can bus:

 

- hold prog button down

- plug in power

- let go of button on blue led

- plug in remaining connectors

- turn ignition on

- what does the blue led do?

---

The blue led goes out when the car is started.  comes back on when turned off.

I should also ask, If I'm using only the remote start with 3X, do I need to connect any additional wires aside from the T_harness?

---

Yes, you need to connect all the wires in the installation guide.

 

I'm guessing that the fact those wires arent connected is your issue:

 

https://fortin.ca/download/97471/evo-one_ig_rto_bi_sub1-impreza_xv_2015_key_a_97471.pdf

---

OK Thank You.  Are there any minimum set-ups?  Would I get by with just the CAN High and Low? Or does every single wire in this diagram need to be connected?

---

horn and parking lights are optional.

 

Everything else is mandatory.