Questions & Answers

2015 Mazda 3 Won't Start after successful Programming/Decrypt

0 votes
Hello,

I am trying to install an EVO ALL as a standalone remote starter unit in a 2015 Automatic Mazda 3 w/Push to Start.

I used a MAZ1 T-Harness to install, and properly soldered in the two CAN wire connections for the door locks, verified D1 and C1 are enabled in the options, and also Disabled A11 as I do not have a OEM Hood Pin, and Wired in the blue hood pin wire to the included hood pin, and installed it. I have verified that when closed, wire is not grounded, and when open the the wire has ground to the unit.

I was able to successfully program 2 keys, and connect the unit to be decrypted, which finished successfully.

Now when trying to start the unit with 3x Lock from outside the car, the car will not start.

Monitoring the LED's on the unit show the Blue CAN light flashing first, triggering the lock sequence, followed by the Red LED turning on solid, then the Yellow LED on solid...but then nothing happens. It then tries to retry the sequence it seems.

I am not getting any Red LED Flashing afterwards at all.
asked Jan 30, 2021 in Mazda by guitarguybs07 (130 points)

1 Answer

0 votes
You need to do the jumper that is shown on page 6 if the vehicle is not equipped with an OEM hood pin : https://fortin.ca/download/62681/evo-all_ig_tsa_bi_maz1-3_pts_2014-2017_door_v2_e_62681.pdf
answered Feb 1, 2021 by derek g (346,810 points)
...