Evo-Fort2 2018 Ford F-150 STX ignition power, no start

Question

Programming successful except for final step. Vehicle power comes on but vehicle does not try to start. I see on the diagram there is a "rs6 in/out ignition +" coming from the yellow A1, I dont know where that wire goes besides to the T-harness. My vehicle seems to be activated by the Evo module, and won't allow key start once that occurs, and won't disable by pressing the brake. Any idea what I'm doing wrong? I did the can high and low taps at the odb, I have a factory hood switch, all light in the programming match instructions, until the point where it's supposed to turn on and then turn back off. Help!!

Answer 1

What is the service number to the module?

Comments

001A06xxxxxx. Thanks a lot

---

Your module is not flashed properly.

 

Please conncet it to the flash link updater and flash and configure the module according the the vehicle you are working on.

---

Thanks for the answer. I'm just a consumer, bought this as an advertised plug and play for my vehicle. I guess I was duped, I have no need to own an updater as I'm not a shop or vendor. Damn......

---

Hello again,

So I sent back my module, and the vendor flashed it for my vehicle. I got it back, tried programming again, didn't work. I checked all my wiring, I assured all wires were making contact, and matched the diagrams. I popped my hood, dash screen reads that hood is open, verified that I do have factory hood pin.

Problem is when I get to the end of the programming routine, the vehicle powers up all electrical devices (screens, hvac, radio), but it does not try to turn the starter. I have a factory hoodpin, and I see one wire on the diagram (Dark Blue) that shows it should be run to the hood pin. Is my vehicle not trying to start because I neglected to run a wire from the fortin module to the factory hood pin? Now I also have a check engine light that came on after the failed programming attempt.

What I have done:

1) Wired the 4 can high and low wires, checked connections. (Issue I see with this, the wire listed as Blue/White Can2High is just Blue, but the pin location matches.)

2) Wired Light blue, light blue/black, and Yellow from the 20 pin connector to the T-harness. double checked all connections.

3) attached both t-harnesses on the steering column

4)program, all successful until final step where vehicle should start.

Any help is much appreciated, I'm so close, but so far.....

---

Honestly the quickest way to resolve your problem will be to call us when you have the vehicle and module and updater on hand.

 

Mon-Fri

1-877-336-7797

8-6 EST.