Immo data is incomplete

Question

2015 Ford Kuga PTS

Problem from 6 step of manual (34911):

6. "Press & release PTS to turn ON ignition, the YELLOW LED will turn on.The RED LED will turn OFF" - yellow lights up but red doesn't turns off

If I press start button several times (turn on/off ignition) - red finally turns off.

7. "Press & release PTS to turn OFF ignition, the YELLOW LED will turn off.The RED LED will turn ON" - the same again: yellow doesn't turn off and red doesn't turn on. I'm pressing again two or more times - yellow off, red on.

8. "Press & release PTS to turn ON ignition, The YELLOW LED will turn on and off.The RED LED will turn OFF. WAIT, the BLUE LED to flash rapidly"  - this time everything is ok.

9. "Press & release PTS to turn OFF ignition, The RED and YELLOW LEDs  will alternate." - OK again.

I'm disconnecting EVO-ALL, go to Dcryptor menu, sending data. After 2 minutes it says "The immobilizer data received from the module is incomplete".

I've tried several times on different firmwares (from minimum 71.35 and higher) - the same problem.

Answer 1

start by enabling the key bypass option. Option A3.

All options labeled A are on by default and should be left on.

Comments

I forgot to mention that I've tried in standalone mode everytime (C1 & D1).

After enabling all A-triggers problem persists.

Guide #34911 Rev. 20160914

---

Key was succesfully read on firmware 4.18

---

After trying to remote start OEM-alarm is starting to beep and IPC shows message "FordKey doesn't recognized. Please insert key in slot"