evo-one does not flashlink2

Question

each time i plug  evo-one on the flashlink udater 2, unit automatcly disconnects after a few seconds.   in remote start mode its ok( i can flash it ) but in bypass mode i cannot doe anything.  tried another module on my flashlink and it goes fine.  Is the evoall part of the evoone defective ?

Answer 1

When toggling between bypass and remote start, the unit needs to be disconnected.

Comments

I know ! :)   I'm sending the unit back as defective. thanks.... i was just posting to see if there was some sort of master reset that could of been done without sending it back to you. thanks

---

I'd start by updating the flashlink updater firmware. Disconnect USB cable, go to Help -> FlashLink firmware update and follow on screen instruction.

---

seriously doubt the evo-one is defective. as Mathieu said, do updates of the actual flash-link firmware first. Don't just deem a unit defective.

Call tech support if you need assistance : 1-877-336-7797

---

im not i my first evo-one install... tried other evo and they work fine just this one does not work.  i do not deem the unit defective it just is.  all the firmware(flashlink2) are up to date and other units works fine so let me know if you have any other option... i would be more then happy to resolved this mystery without sending the unit in.. thanks