Evo all works fine, added Evo start lte with the rfa2a cable.

Question

The Evo all has been installed for almost a year and works fine, even after the failed Evo start lte.  I plugged the blue connectors from the rfa2a and the start wire harness. Unplugged the 4 wire data plug from the Evo all, taped off it off for protection, and plugged the 4 wire data plug from the rfa2a harness. The black and red wires are not connected and taped off.  When I go to program the start, by disconnecting the data port and holding the program button nothing happens. I used the harness for my car also when installing the Evo all. I also flashed the Evo all . Did I miss a step or something?

Answer 1

Hello,

Sounds like you missing power and ground if the unit does not light up.

https://cdn02.fortin.ca/download/102151/EVO-ONE_IG_EVO-START_QUICK-GUIDE_F_102151.pdf

If a t-harness was used you with the evo-all should be plugging in the black 4 pin connector with a clip into the rfa2a. Then plug in the evo-start-lte to the blue connector on the rfa2a, then plug the rfa2a into the evo-all module.

Best regards.