2013 Hyundai Genesis Coupe auto- Alarm going off after remote starting

Question

Had the EVO ONE installed for about a year with all the functions working. The engine locked up and after the dealer replaced it everything still works except when you remote start about 20ish seconds past and the car alarm will go off. I've tried changing some settings, the master reset ( plug in the big connector and let the button go when its red then hold again until it cycles) then flashing it again still no change. I checked the wiring and found no breakage or cuts.

2 things I've noticed is that if I'm trying to do the KEY BYPASS PROGRAMMING PROCEDURE after I get solid yellow and I plug in the rest of the connectors and turn the car on the light does not change, tried about 4 times, but when I do the PROGRAMMING VEHICLE WITHOUT PATS DATA WIRE (even thought I did the PATS wiring like the diagram said) I get through all the steps no problem and end up with the original issue.

2nd thing is when I remote start it unlocks then locks and starts (like it should) then after a couple of seconds it locks again which I feel like its arming the alarm because I tested unlocking the car after that second lock and around the time the alarm would normally go off it doesn't but what happens is the car relocks its self then after some seconds the alarm goes off again.

Also note if I turn the alarm off the cycle of the car locking itself again then the alarm going off will continue forever until I either disable the remote start or put my key and turn it to the on position

To me its sounding like the EVO one isn't acting like the "key" which points to the key bypass Issue and I cannot seem to find a forum about the problem I am having

Answer 1

Hello,

I know you said you reset it already but please try the following:

- In pro mode at the flasher with the unit plugged in, turn off settings protection, save it in the off position

- Return to the vehicle and perform a master reset on the evo one (please note for evo one you will connect the main 6 pin connector with power and ground in place of the 4 pin as mentioned in the instructions): https://cdn.fortin.ca/en/download/61931/61931.pdf

- Plug the unit back into the updater, turn on C1 and D2, Turn off A11 then click save optinos

- Return to the vehicle and re program the module to the car (please pay close attention to the led's on the evo and note down if they vary from the progrmming at all, you should get the blue led flashing rapidly after key on, wait for yellow and red, then cycle the ignition again and wait for yellow to flash rapidly)

- Re test