Vehicle starting but messing but

Question

I have a 2014 Infiniti Q50, bought the EVO ALL with the thar-nist4 t harness. installed everything and programmed the module and the vehicle started. going inside the car, tried to press the push to start button and no response whatsoever. pressed the key 3x lock to shut the engine off and it turn off all the electricals but engine stayed on with no control at all. unplugged the module from the wires and vehicle turned off instantly and gained all access to vehicle again. Is there something I am doing wrong or is my EVO-ALL module defected? please help...

Answer 1

What is the S/N number to the module? This is located on the back of the unit.

Comments

SN: 001A07 018627

---

The flash and options look ok.

 

Was the white 15 pin connector on the t-harness plugged into the BCM?

---

Everything was plugged in, I did not understand why it was required to cut the white connectors but I didn't do that, would that be causing the issue? And do you have a video of another person installing it so I could see what I was doing wrong?

---

That is your issue. You cannot use the white 15 pin connector. You must manually connect power and ground as shown in the guide: https://fortin.ca/download/75841/evo-all_ig_tsa_bi_nis4_q50-6c_2014_pts_b_75841.pdf

 

Fortin does not make videos at this time.

---

Okay, I will try that. Anything else should I check for? Or any options that I should keep on or off?

---

No the rest looks ok. Simply make the changes that are shown in the installation guide.