tundra install issue now factory remote start dead

Question

so i have a 23 tundra non hybrid  that i couldnt get evo one to work and now  factory remote isn't working.first off didnt want to pay 15/m for  toyotas sub par remote start but i guess im going to have to now. i  triple checked the wiring /splices prior to install so wiring was good. followed the procedures and all the lights during setup worked the dycriptor worked, but when i went to remote start nothing except my key fob  temporarily stopped responding to doors and push button. so i went back and changed the setting to unlock door prior to start and nothing but key fob not responding no push button start. not knowing what caused it i removed it reconnected the pink wire and after a few min i could start the car and open/close doors. went in the toyota app subscribed to the remote connect and all is well  except remote start is no longer working gives me a d5 error and to contact dealer. every thing else in car works just not remote start. so i connected my scan tool and now i get an u111787 lost communication with accessory gateway for bcm and special key  did i fry the control module or did i break the pink wire in connector. like i said every other function works just fine only remote start ive installed the evo one multiple times in older cars with out a problem. im hoping when i take it to dealer its an easy fix like a relearn or something but i fear  it will be an expensive fix

Answer 1

Hello,

You would need have the OEM starter re enabled by the dealer scan tool. When programming the evo it turns off the OEM starter.

Best regards.