Questions & Answers

2018 Dodge Journey Can high and can low location. Guide #73591

0 votes

I see that there are can bus connection at the junction block per the pictures on the guide and from wire colors, but I cannot see for sure which are the white green and white blue connections. Is it possible for me to access these from the obd2 Port? I'm using the thar-chr6 harness. I see that pin 6 is can high, and pin 14 is low. Is it possible to use these? On the obd2 Port I mean.

 

:EDIT:

There are no white/green and white/blue wires where the guide says they are. I'm at a standstill until I can figure this out.

The guide might need a rivision, I also cannot find a pink/white ignition wire behind the driver side kickpanel. The two I found are .05v and 12v, nothing I can find is 9v.

asked Oct 19, 2019 in Dodge by Justin Stroud (270 points)
edited Oct 19, 2019 by Justin Stroud

1 Answer

0 votes
Remove some of that tape and you will see the only 3 pin connector in the green junction block.

 

The pink/white may read more than 9 v. As long as it acts like a switched ignition you are fine.
answered Oct 21, 2019 by derek g (342,790 points)
How is everyone getting up there? That is a crazy tight fit, I'm not even sure how I'm going to splice into them. I've removed the lower dash below the steering wheel.
commented Oct 21, 2019 by Justin Stroud (270 points)
Did you ever find a solution for access to the green junction block. I am in a similar situation.
commented Apr 5, 2020 by Brian Reilly (130 points)
Did you have luck splicing the Can  Wires? and how did you do it?
commented Dec 10, 2020 by Mario Diaz (150 points)

Related questions

...