Questions & Answers

Can't get EVO GMT3 to work, can get to Step 5 with Yellow & Red lights blinking, only wired, unlock, lock, cansw wires

0 votes
GMC.2014.Sierra.1500.Checked.unlock.lock.CanSW.wires.everything.look.good,
closed with the note: 2 open threads for same vehicle
asked May 28, 2018 in GMC by Jazz Grewal (190 points)
closed May 30, 2018 by J M

1 Answer

0 votes
Try this for me:

- Plug in only the red connector to the evo, then start the car with the key and let it run for 30-45 seconds.

- From this point forward do not unplug the red connector.

- Turn truck off, remove key from cylinder and leave truck sit for 1 minute.

- Now try the programming procedure listed in the guide.
answered May 28, 2018 by derek g (342,740 points)
I.forgot.to.mention.that.i.also.have.an.aftermarket.alarm.with.keyless.entry.
commented May 28, 2018 by Jazz Grewal (190 points)
Did you try the above mentioned steps?
commented May 29, 2018 by derek g (342,740 points)
Sorry, yes I did try these steps and I was able to complete EVO programming process but now I cant remote start I only get one light when pressing lock even if I press lock key 3 times. And when I press unlock no light shows up on EVO
commented May 29, 2018 by Jazz Grewal (190 points)

Related questions

...