No lights on the EVO-ALL, no remote start working on 2014 chevy cruze

Question

Hello,

I have a 2014 Chevy Cruze I'm trying to set up in stand-alone configuration with an EVO-ALL.  Service number is 003606 007301.  Flip-key, not push-to-start.  I have the flash-link-4 module, which seems to be working fine.

Unit appears to be doing nothing at all.  Initially, when I plug it in, all 3 LEDs flash simultaneously a few times, then nothing happens.  To be clear, after the initial plug-in, no lights appear on the EVO-ALL at all, even when a button is pressed on the remote (I believe I read that I should see the blue light flash indicating data is being passed, is that correct?).  Does this mean my CAN-connector is not connected properly?

I am plugging in the 4-pin connector first, as per the instructions, then the rest of the wires.  

I don't care whether it's lock-lock-lock or lock-unlock-lock (as I currently have it programmed).  I've tried both ways.  What am I doing wrong?

Answer 1

You are not holding the programming button when inserting the 4 pin connector. Read programming instructions carefully.

Comments

Good morning,

I've tried that as well.  Here's what I've done:

Completed physical installation of all wires.

Attempted regular programming procedure, failed, moved on to DCRYPTOR programming procedure.

Completed DCRYPTOR programming procedure successfully.

Attempted regular programming procedure again, but cannot get past step 5.  Lights stay flashing red.

---

Good morning,

I've tried that as well.  Here's what I've done:

Completed physical installation of all wires.

Attempted regular programming procedure, failed, moved on to DCRYPTOR programming procedure.

Completed DCRYPTOR programming procedure successfully.

Attempted regular programming procedure again, but cannot get past step 5.  Lights stay flashing red.

 

 

---

---

Jason, if the regular programming does not work, you need to use the Dcryptor programming. Once that's done, its over, no need to try and do the regular prgoramming again. Just plug the unit in after the Dcryptor is done, do not try to reprogram

 

It's one or the other but NOT both.