Questions & Answers

Can't get evo all to do step 4(ign on flashing blue light) in programming

+1 vote
2002 ford focus using evo all. I can't get the blue led to flash once I turn on the ignition. I had previously programmed the evo all to work with a 2012 Toyota tundra, but I never installed it. So I reset the  evo all and reinstalled the 4.18 software to work with the ford. I tried multiple times, no luck, any ideas?
asked Nov 16, 2014 in Ford by steve capitao (600 points)
edited Nov 17, 2014 by steve capitao

2 Answers

+1 vote
 
Best answer
Blue LED is can programming, on a 2002 focus there is no can, you car following the wrong programming. If you are following DCRYPTOR programming, proceed to transponder programming.
answered Nov 17, 2014 by Micheal Unger (85,210 points)
selected Nov 17, 2014 by Robert T
+1 vote
Any chance you might have Rx and Tx mixed up? I have done this myself before, also had exact problem as you tonight on an escape, turns out there were more data connections to add than recommended in the guide. Hope this can be of some use to you. Mike Unger.
answered Nov 17, 2014 by Micheal Unger (2,680 points)
Little tip about Rx and Tx. Rx is always pin 4 in the transponder connector. Ignore the colors, I've seen colors of Rx and Tx be swapped on the same model truck between 40 and 80 bit keys
commented Nov 17, 2014 by Robert T (300,340 points)

Related questions

...