Questions & Answers

Does wire A16 (purple/yellow) need to be tapped into wire A10 (lt. blue/black) 2013 Infiniti G37 sedan/evo-nist1?

0 votes

Does wire A16 (purple/yellow) need to be tapped into wire A10 (lt. blue/black) 2013 Infiniti G37 sedan/evo-nist1?

The wiring diagram for a 2013 Infiniti G37 sedan, using an EVO-NIST1 shows that the A16 (purple/yellow) wire needs to be tapped into A10 (lt. blue/black) wire. 

Im trying to see if this in necessary because both wires are attached to the same connecter. Furthermore, none of the install videos I have found for this set up and vehicle have mentioned connecting these wires to one another. What will happen if it is not connected?

asked Oct 5 in Infiniti by Jonatan Quintana (230 points)

1 Answer

0 votes
Hello,

Yes both wires must be spliced onto the lt.blue/black of the t-harness. It is mandatory.

If it is not connected you may get intermitent remote starting. In some cases it may also hinder in vehicle programming.

Best regards.
answered Oct 7 by derek g (342,860 points)
Two wires need to be spliced onto A10 (the lt. blue/black wire)? My diagram only shows one, A16 (the purple/yellow wire).

What other wire am I missing?
lt.blue/black and purple/yellow from the 20 pin connector both go to the loose lt.blueblack wire coming out of the t-harness
...