Questions & Answers

2019 Veloster PTS Manual, Bypass wont program

0 votes
2019 Veloster PTS Manual.  Wire to wire according to https://fortin.ca/download/98741/EVO-ONE_IG_RTO_BI_KHY8-VELOSTER_2019_PTS_B_98741.pdf

Bypass wont program when ignition is pressed twice.

Any advice on troubleshooting would be greatly appreciated.
asked Oct 31, 2023 in Hyundai by Alex McLean (160 points)

1 Answer

0 votes
Hello,

What is the S/N to the module?

 

Also looks like there is 2 brown wires in the blue connector, id be making sure you went to the right one.

Make sure you connected the lt.blue/black wire to the ems com wire.

Are you able to program on just the blue led? Let go on blue, plug everything in, turn ignition on. Does blue led flash?

 

Best regards.
answered Oct 31, 2023 by derek g (342,740 points)
S/n 002B04201778

Quite confident I'm soldered to the correct wire but will verify this evening.

Is there anything else I should look into other than programming on blue LED?
commented Oct 31, 2023 by Alex McLean (160 points)
edited Oct 31, 2023 by Alex McLean
Hello,

Flash looks good.

I would try those things mentioned, double check ems com, make sure you grabbed correct wire from evo and try can bus only programming.

Let me know what you find!

 

Best regards.
commented Oct 31, 2023 by derek g (342,740 points)
Connected to the correct wire on both the blue factory connector and the blue with black stripe wire on the Evo-one.

No luck with can bus only programming. Light stays solid when ignition is pressed
commented Oct 31, 2023 by Alex McLean (160 points)
edited Oct 31, 2023 by Alex McLean
Hi Alex, we just spoke. If you get a minute please send a picture of that 6 pin harness with the reversed wires for pink and yellow to support@fortin.ca
commented Oct 31, 2023 by Robert T (300,340 points)
This has now been sorted out. Pink ignition wire and yellow starter wore on the 6 pin connector were pinned incorrectly from Fortin.
commented Oct 31, 2023 by Alex McLean (160 points)

Related questions

...