OEM Remote disabled after remote start via 3x Lock (EVO-ONE with T-Harness for 2014 Honda Odyssey)

Question

After installing and configuring the EVO-ONE with T-Harness for our 2014 Honda Odyssey with Push to Start, everything is working properly, except that the OEM remotes become non-functional after starting via the "Push lock 3 times" method. Since we have not purchased a separate RF remote, the only eay to get into the car is if we leave a window open. Otherwise, we have to wait until the remote start time runs out, at which point the OEM remotes become operational again.

The blue light on the EVO-ONE box does not light after remote starting the vehicle and remote buttons are pressed.

Answer 1

In the installation guide there is a modification that must be done to the t-harness to make this feature work. Look carefully at the green/red and green/white connections.

http://cdn.fortin.ca/download/65001/evo-one_ig_thr_bi_hon4-odyssey_pts_2016_b_65001.pdf

Comments

Thanks for the response. Yes. I have verified multiple times that the green/red wire is connected to the appropriate pin on the blue connector (going to the smart module) and the green/white whire is connected to the other side of the same wire (going back into the T-Harness).

I also tried reversing the green/red and green/white wires. In this configuration the car would not start using the push button.

I will pull the T-Harness back out to check again. Are there any other potential causes? Other things to check (which lights are on after remote start, etc.?)

---

The guide also ask to cut the white wire in the large 6 pin connector. If this is not done it will also prevent the oem remote to be functionnal when the engine is running.

---

Ah. I believe that is the culprit. Thank you! I will confirm this evening.