Questions & Answers

Evo one CHR4 dodge challenger 2010 no any action only security light flashing

0 votes
2010 Dodge challenger SRT with stander key and manual transmition

Module programming okay

blue light flash every press lock

Remote start red light one and give 2 sound then off

dashboard securty light flashing

Evo one with Chr 4 T-Harness

please help
posté Fev 7, 2023 dans la catégorie Dodge par Ahmed Ali (240 points)

1 Réponse

0 votes
Hello,

 

What is the S/n number on the back of the module?

 

Best regards.
répondu Fev 9, 2023 par derek g (340,410 points)
SN: 002B04250193
commenté Fev 9, 2023 par Ahmed Ali (240 points)
Being manual transmission, how was the clutch circuit bypassed?

Also does ready mode work?
commenté Fev 9, 2023 par derek g (340,410 points)
No anything working. I see only the red security light ( key light ) flashing
commenté Fev 10, 2023 par Ahmed Ali (240 points)
No ready mode Dashboard no any light only red security flashing
commenté Fev 10, 2023 par Ahmed Ali (240 points)
Plz help
commenté Fev 12, 2023 par Ahmed Ali (240 points)
Being manual transmission, how was the clutch circuit bypassed?

 

When you try to set ready mode, what do the led's on the evo one do?
commenté Fev 13, 2023 par derek g (340,410 points)
I use evo one for manual transmission Remote start red color and every lock pressed blue light flash one time
commenté Fev 13, 2023 par Ahmed Ali (240 points)
It is difficult to determine where your issue is comming from sir if you do not answer the questions asked. Please answer the following questions so that I may assist you with your issue.

 

Being manual transmission, how was the clutch circuit bypassed?

 

When you try to set ready mode, what do the led's on the evo one do? What is it you are doing when setting ready mode? I.E. what process are you following?

 

Best regards.
commenté Fev 13, 2023 par derek g (340,410 points)
Morning. Regarding manual transmission i didn't make anything Rrady mode. I program the device same your instruction on your site If i press lock evo one led light flash one If i press 3 times lock the evo one remote start led red light on then i hear noise 2 times That is all If you want i can send vedio to you
commenté Fev 15, 2023 par Ahmed Ali (240 points)
You must wire in a clutch bypass for this vehicle to remote start.

 

Once that is done you can refer to this guide on how to set ready mode.

 

https://fortin.ca/en/download/87611/87611.pdf

 

Best regards.
commenté Fev 15, 2023 par derek g (340,410 points)
Which wire from evo one need to connect with clutch ?
commenté Fev 17, 2023 par Ahmed Ali (240 points)
That depends, is the clutch in the vehicle positive or negative?
commenté Fev 17, 2023 par derek g (340,410 points)
Let me know if positive which one ? Also If negative which wire ? Iam small shop for remote start you can check my page on Instagram AKSSWARAATY i use always fortin
commenté Fev 18, 2023 par Ahmed Ali (240 points)
If it is negative it would be the small white wire on the 20 pin connector of the evo one.

If it is positive it would be the large yellow wire on the main 6 pin connector of the evo one.

 

Best regards.
commenté Fev 20, 2023 par derek g (340,410 points)

Questions associées:

...