Questions & Answers

how can I reset the evo one and start over I can't remote start my Pathfinder

0 votes
I purchase a evo one for my 09 Nissan Pathfinder hook it up with the T-hareness but had problem with the locks locking after I stop the start moving again so I purchase the Flash Link up dated everything then hook it back up tryed the remote start not working would like to know if there is something else I can do I recheck my wireing eveything is good on that an
posté Oct 18, 2016 dans la catégorie Nissan par Abraham White (180 points)

2 Réponses

0 votes
 
Meilleure réponse
Try cycling the module in and out of valet mode as follow:

1- turn ignition ON

2- press the valet switch 3 times

3- turn ignition OFF

This should turn off the red led under the yellow loop.

once the red led is out then try remote starting your vehicle.
répondu Oct 19, 2016 par derek g (339,570 points)
élue Oct 21, 2016 par derek g
the red light by the loop is flashing 4 time now an it did not remote start

and the light did cut off
4 flash is valet mode active...try doing the test previously mentioned to exit valet mode.
now there is 3 flash in the horn sound 2 time
I turn the valet mode off it still doesn't

start
did you cut the yellow loop on the evo-one? If the vehicle has a automatic transmission cut the yellow loop and re test.
Yes the yellow loop is cut and it is

automatic  the light on the dash come on

when it try's to crank but that's it
Did you flash the module at any time after receiving your flash link updater?
Yes that when it stop working
Hi Derek is there something else I can try
re program the module in the vehicle.
How ? I try unplugging everything holding the button buy the yellow loop wire

then plugging the 6 pin connector I get no lights to come on
redo the bypass programming on the module as shown in the installation guide you followed.

If no lights turn on when you hold down the programming button and insert the 6 pin connector verify power and ground to the module.
Getting power and ground but no lights
is anything else plugged into the evo-one when you are holding the programming button down and inserting the 6 pin connector?

Also you are holding the programming button right? Not the valet button.

Also, you can always give us a call when you are in the vehicle and we can go through the troubleshooting together in the vehicle to see what's going on. our number is toll-free 1-877-336-7797

ask for Derek :)

Ok I will call later today
Customer called in and spoke with me.

Master reset of both bypass and remote starter, Reflash both remote starter and bypass, reprogram the module and everything worked as it should :)
0 votes
What does the lights on the module do when trying to remote start ?
répondu Oct 18, 2016 par Abraham White (85,210 points)
There is no lights on module except the red light beside the learn button
THANKS

Derek you help me out a lot when call you walk me thru the resetting

the Module so I can get Pathfinder up an running.

THANKS AGAIN!!!!
...