Questions & Answers

Unable to program EVO-ALL to Volvo S60

0 votes
Installed EVO-ALL into 2005 Volvo S60, begin programming - blue LED on, once i put key in ignition, Light goes out.  turn the key to acc, and light stays out.  light comes back on when key is taken out of ignition.
posté Dec 7, 2013 dans la catégorie Volvo par Ken White (190 points)

1 Réponse

0 votes
what is the 12 digit service nunmber of the EVO? (if you still have it)

It's acting like if it's not detecting the Can-Bus. This may be fiirmware related or connections.
 

I'd recommend trying a Master Reset on the EVO:

1- Hold down programming button while plugging in datalink connector.
2- Let go of button when LED is RED.
3- Push and hold button again until all three LEDs start to alternate.
4- Disconnect unit, she is now reset.
répondu Dec 9, 2013 par Robert T (300,020 points)
Service # is 001A06 221229
Try that master reset and re-attempt programming. If it does the same thing, you will want to look at the Can-Hi and Can-Lo connections.
Have tried the master reset and re-programming with no success.  Re-checked Can-Hi and Can-Lo, both are good connections.  Tried moving can hi and lo from DLC to harness in drivers kick.  still nothing.  Re-checked all connections, everything looks to be ok.  My main power is in drivers kick panel at red wire, starter is yellow/white at ignition, accessory purple at ignition, ignition blue/red at ignition.  key sense is from EVO-ALL to yellow wire at ignition.  The remote starter is an Autostart AS-1780.
Try firmwares:

77.06, 4.18 and 4.06. Tell us what happens when trying each one.
I have the same exact issue with an 06 .any idea what it could be?
I tried updating to 4.18 but that didn't change anything.
Were you ever successful in getting your Evo-All and remote starter to work ?  If so I'd like to talk to you about it ...
...