Questions & Answers

Evo all with Start 2 For Corolla 2022 Push Start

0 votes
I havs install evo all with start 2 for mobile support. The module is programmed when i press lock key on remote the blue led indicates with each click and after red led turned on same is with remote start app but my car is not starting. is anyone here help me to troubleshoot pls?
posté Sept 17, 2023 dans la catégorie Toyota par Dhimanchandan786 (180 points)

1 Réponse

0 votes
Hello,

What is the s/n number on the back of the module?

When the vehicle attempt to remote start does the ignition turn on? Does the engine crank?

Best regards.
répondu Sept 18, 2023 par derek g (339,570 points)
Hello sir,

No its not starting, no crank sound i think some program issue. Or pairing. After running firmware when i connect all the wires to module after making blue light on on module the manual said turn on ignition and then wait for blue light to blink and then turn off ignition. But in my case nothing work after that. So i repeat the process and then tap the evo all button 3 times when the blue light blinks, then it gets paired but no start.

Can you help pls?
S/N:001A07273484
Hello,

 

If you press lock on the oem remote does the blue led on the evo-all blink?

If yes, what happens if you make it blink 3 times in a row?

What procedure did you follow to pair the remotes/evo start2 to the unit?

 

Best regards.
Yes, it blinks

But no start.

My car is corolla 2022 se

I follow the same manual they mentioned for corolla 2022
With T harness
Hello,

Please perform a master reset on the evo-all:

https://fortin.ca/en/download/61931/61931.pdf

Once that is done, re enable the stand alone, push to start and rf options. Followed by re programming the module to the vehicle and afterwards re pairing the rf kit to the evo.

 

Once that is done re test 3x lock start.

 

If it is still not working at that point please contact technical support directly at:

1-877-336-7797

Mon-Fri

8 am to 6 pm EST.

 

Please be sure to have the vehicle and module on hand when calling in to diagnose the issue.

 

Best regards.
Getting en error

Decryptors limit exceed
The dcryption limit has been reset.
Evo all working for my call. Everthing all good. I installed evo start 2 its getting command and working good but in app its showing unlocked but my car is locked.

Even not getting correct location.

Anyone can help please
Depending on location and network signal strength, you may not always receive feedback from the device.

The yellow wire of the evo-start2 should be connected to ignition for it to read the statuses properly.
Yellow wire is connected.

Temperature and battery is showing there.

But problem is with door lock status as it showing unlocked but actually its locked and not countdown after start.

And no location updation
Area is not a problem we can get feedback as its brampton, ontario.

I think its something else
...