Wiring issue Mazda 3- 2015-PTA-Automatic

Question

I boutght The mazda EVO-All with T-harness for my 2015 Mazda PTA automatic and I am confused about the wiring on number 2,3 and 4 in red circles.

On guide #62681 page 6 at the bottom of the page(#2 in red circle) it says that I need to connect LT.BLUE/BLACK Wire to Pin#8 and the Lt.Blue wire to #9 pin on 32-pin White connector.my question is how am I supposed to do this?Do I need to disconnect the 32-pin White connector from Car and connect these 2 wires individually to the part which is attached to the car or the part wich I disconnect from the car?there is no conncetor in the harness to connect these 2 wires.

I have the same issue with #3 and #4 in RED circles at the bottom of the page 6 as-well.how am I supposed to conncet the D section on Evo-All to #1 & #3 on the 8-pin White connector and also connect 4A an 4B on the engine compartment.

I do not see any part on the harness to coonect these parts.am I supposed to buy connectores,strip the wires and attach the wires by myself?there is no extra connector or pin or wire stripper in the package.

Thanks for your help.

 

Answer 1

The t-harness plugs into 1 plug, the other connections are physically connected to other wires on the car in a different plug.

 

Remote starters do not come with wire strippers or any type of plastic connectors. A remote starter should always be installed by a trade professional with the tools and experience to do the job.

 

If you plan on attempting a remote starter installation on your own vehicle, please consider looking into the EVO-ONE + THAR-ONE-MAZ3 instead the EVO-MAZT1 kit that you currently have.

Comments

Thanks.I did it and bought THAR-Maz3 with Evo-one and Evo Start2.

my question is that Do I need to install and program Evo start2 while I am programming Evo-one or I must programme Evo one first and after that disconnect all the wires to install and program EVO START2.
I can't  find any instruction about which one should I program first.

---

Hello Saeid

Did you find a way to connect the EVO Start2 and programme it?

Would you please send me an email as I have the same issue with my Mazda 3?

smatin4@uwo.ca