Questions & Answers

programing

0 votes
hooked up all wiring and im at the programing get to where you plug in the 6 wire power and hold the program buton down till the red and blue lights are on the plug in the rest of the plugs and hit the program button 2 times and turn the inj swith on and the only light thast will light up is red , then try to start up with the remote it will start then die and try t start agian but just cranks
posté Dec 27, 2016 dans la catégorie Toyota par tracy mcanelly (160 points)

1 Réponse

0 votes
When turning ignition on, does the blue and red go out ?

You should make sure small yellow wire is on ignition and that light blue/black is on the correct wire in the vehicle.
répondu Dec 28, 2016 par tracy mcanelly (85,210 points)
wires are hooked up per instructions , when turn key on only red light flashes
Does it flash 10 times or it never stops ?
the red and blue lights come on and flash , but when to turn the ing switch on blue light goes out and only red light is on and flashes hit the remote to start the truck the truck starts up runs for about 10 sec then dies and waites for about 30 sec and trys to start agian and just cranks  no start
...