Questions & Answers

Cant program revo-1 rf to evo-one

0 votes
So im trying to get the revo-1 one button rf remotes to program  and i cant get a response from the Evo-one. i set option fortin2 in rs side, programmed evo to vehicle,

i turn ign on hold valet switch get the blinking red light, press 5x hit the brake and press button on remote but dont get any confirmation, red light does blink once when i step on brake tho. the antenna is plugged into blue rf port

and other end to antenna any ideas? On a side not I wires using this diagram https://fortin.ca/download/29781/evo-one_thar-one-toy1_iq-ic-4runner_c20150317.pdf I cut the auto light wire and connected yellow red to one end yellow green to the other now under normal operation the auto lights never shut off
asked Dec 11, 2016 in Toyota by Thomas Osgood (280 points)
edited Dec 12, 2016 by Thomas Osgood

2 Answers

0 votes
Did you figure it out ? I have the same issue. what was it?
answered Dec 28, 2016 by Kelly Bochniak (340 points)
0 votes
I'm having the same issue, everything goes smoothly up until trying to register the remotes.
answered Jan 13, 2017 by Neseth Kong (200 points)
I lowered the firmware on the remote start side to 1.16, per a conversation with crimestopper and it worked. Only thing is the oem key fob bdoesnt work in remote start mode. Not sure how to fix that yet.
I don't think the OEM fob is supposed to work while the car is running in remote start.  Pretty sure you have to use the new fob, except yours doesn't have any lock/unlock buttons.
...