Questions & Answers

2011 ford edg with crimstoper remote will not program car will remain running after key is out

0 votes
the yellow/ black from t harness shows 12 volt with the key in but not on. is this correct  that wire is to be connected to the ignition from car starter and the yellow from evo. has been flashed to harware 6 and firmware 71.28
asked Feb 11, 2018 in Ford by Corey Johnson (140 points)

1 Answer

0 votes
Yellow/Black comming from the t-harness is connected to key sense of the vehicle.

If when you insert the key it goes to 12v and then drops to 0v when the key is on, it means their is an issue with the keysense in the ignition switch itself, Key sense should always have 11-12v when the key is in the ignition regardless of its position.

 

Common issue ive seen on ford suv/trucks year range 2011-2014.
answered Feb 12, 2018 by derek g (324,940 points)
...